Simulation is more than Software

Directcontact
0
Wishlist
0 0
Cart
EN
Spotlight on 3d printing: avoiding misprints through precise analysis and optimization of the future product and printing process

Recording and follow up info of the Simulation Conference 2021 event from Thursday, Oct 07, 2021 (Conference language was German)

Follow up information
  • Webinar
  • Journal Articles

Additive Manufacturing - Optimized Components and Processes

Recording of the Simulation Conference 2021 on Thursday, Oct 07, 2021

Content of the event webcast

The use of simulation software is an important factor when it comes to cost-efficient additive manufacturing. Due to the fact that 3D printers have expensive lifecycles, printing errors can quickly prove critical to any budget – and it therefore makes sense to use simulation during the development process itself to pinpoint which areas of given components are going to be susceptible to errors in the printing process.

Ansys provides a very broad spectrum of solutions for this type of work, covering everything from PBF (PBF) process simulation to DED (direct energy deposition) and Binder jet 3D printing, and also parameter development, optimization of topology, job preparation, and materials management.
 

2.00Welcome & Introduction
2.103D-Druck an der Schwelle zum etablierten Produktionsverfahren
Simon Höges (GKN)
2.45Geometrieeinfluss auf die Materialeigenschaften additiv gefertigter Bauteile aus TiAl6V4
Juri Munk (Fraunhofer ILT)
3.10Break
3.20“Get on track” mit Ansys DED Simulation
Keno Kruse (CADFEM)
3.45Sintering simulation in scope of Binder Jetting
Fabian Peter (Fraunhofer IWS)
4.15Weniger ist mehr – Möglichkeiten der Topologieoptimierung vom Bauraum bis zum fertigen Produkt
Florian Hollaus (CADFEM)
4.40Experteninterview: Material + Prozesse im Griff behalten
Cord Steinbeck-Behrens, Keno Kruse (CADFEM)
5.00Conclusion & Outlook

Request Video Download

*Mandatory fields

Contact

Technical

Business Development

Organisational

Corporate Marketing