Simulation is more than Software

0 0
Technology Day: Verification of welds

December 2, 2021 | 10:00 a.m. - 12:00 p.m.

Reliably evaluate welds with Eurocode and FKM

Learn more about the challenges in weld calculation and weld concepts, which can lead you out of the impasse. You will learn how to verify welds in Ansys.

What can you expect?

Weld seam calculation often poses challenges for design engineers. Learn how weld concepts show you the way out of the dead end. We will show you how to verify welds according to Eurocode 3 with Weld Toolkit and the FKM guideline with FKM inside Ansys.


Thursday, December 2, 2021, 10:00 a.m. - 12:00 p.m.

The language of the event is German. The lectures are held in the language of the lecture title.

10:00 – 10:10Introduction
  • Herausforderungen bei der Schweißnahtberechnung
  • Singularität - Schweißnahtkonzepte, der Weg aus der Sackgasse
  • Mit Richtlinien (IIW, FKM, Eurocode, ASME etc) zur finalen Aussage
Florian Mailänder (CADFEM)
10:10 – 11:50 Verification of welds in Ansys
According to Eurocode 3 with Weld Toolkit | Magnus Gustafsson (EDRMedeso)
Nach FKM-Richtlinie mit FKM inside Ansys | Florian Mailänder (CADFEM)
11:50 – 12:00Wrap-up


Participation in the Technology Day is free of charge, registration is required for organizational reasons.