Simulation is more than Software

Directcontact
0
Wishlist
0 0
Cart
EN
Technology Day: Verification of bolted joints

November 30, 2021 | 10:00 - 12:00 h

Safe bolt verification with Eurocode and VDI 2230

Learn more about the challenges of bolt calculations and how to verify joints in Ansys.

What can you expect?

Bolt calculation often poses challenges for designers. Learn, right down to the last detail, how bolt calculation works and the importance of guidelines. We will show you how the verification of bolted joints according to Eurocode 3 is carried out with Bolt Toolkit and VDI Guideline 2230 with Bolt Assessment inside Ansys.

Agenda

Tuesday, November 30, 2021, 10:00 a.m. - 12:00 p.m.

The language of the event is German. The lectures are held in the language of the lecture title.

10:00 – 10:10Introduction
  • Herausforderungen bei der Schraubenberechnung
  • Schraubenberechnung bis ins letzte Detail und die Bedeutung von Richtlinien
Instructor: Florian Mailänder (CADFEM)
10:10 – 11:50 Verification of bolted joints
According to Eurocode 3 with Bolt Toolkit | Instructor: Magnus Gustafsson (EDRMedeso)
Nach VDI-Richtlinie 2230 mit Bolt Assessment inside Ansys | Instructor: Florian Mailänder (CADFEM)
11:50 – 12:00Wrap-up

Registration

Participation in the Technology Day is free of charge, registration is required for organizational reasons.